Setting NetFlow Collection Port

When you start the NetFlow Analyzer for the first time, you need to set NetFlow collection port before you can see traffic.

NetFlow collection port is a port on NetVizura server listening for NetFlow traffic exported by network devices. You need to set exporting port number on all your network devices to match NetFlow collection port. Default port number is 2055.

To set the NetFlow collection port:

1. Go to  > Settings > NetFlow Settings > Configuration tab
2. Type a new value in Collection port field
3. Click Save.
   
   

Checking the System

Now is a good time to check if the system is working properly.

To do so, follow these steps:

1. Check if the Collection port is set properly
   To see the Collection port number, go to  > Settings > NetFlow Settings > Configuration tab, and you will find the Service socket port field. Collection port number must match with the port number your network devices are exporting the netflow data to.
   
   
2. Make sure NetFlow data is collected
   Go to TopN > System tab. Packets tab shows if netflow UDP packets are received and Flows chart shows how many flows have been exported to NetVizura server
   
   

3. Check the system for warnings or errors.
   Click on the Show log arrow (in the bottom right corner). Any warnings or errors will be displayed as well as the instruction to resolve them. 
   
   

4. Finally, check if the network traffic is available
   Go to TopN > All Exporters tab. Network traffic should be shown on the graphs, this is a verification that the network traffic data has been collected by the NetFlow Collector and that the data has been processed by NetFlow Aggregator.

 Note that it may take up to 10 minutes to see traffic from a new exporter. This is the time needed for the application to create the finest sample of traffic since one sample lasts 5 minutes and two samples are needed to draw a line on the chart.

Setting End User Traffic (Optionally)

In addition to general network traffic (Exporters, Traffic Patterns and Subnets Sets), you can view traffic made by organization end users (domain usernames).

To setup this traffic:

1. Check if the Collection port is set properly
   To see the Collection port number, go to  >Settings > NetFlow Settings > Configuration tab, and you will find the Service socket port field. End users collection port number must match with the port number your Syslog agent is exporting the logon syslog messages to.
    

2. Update existing or add new End User mapping rule

   If you use Snare as your Syslog agent, then you can use one of the provided mapping rules. In this case, just update Source IP field, verify if rule is matching users and change status to Active. To do so, go to  > Settings > NetFlow Settings > End Users.

   If rule for your Syslog agent is not provided with NetVizura by default, you should create your own rule in order to successfully map users (link username with an IP address at specific time). Read more about how to setup custom End User mapping rule in the the article Configuring End Users.
    

3. Finally, check if the network traffic is available
   Go to TopN > End Users tab. Network traffic should be shown on the graphs, this is a verification that the network traffic data has been collected by the NetFlow Collector and that the data has been processed by NetFlow Aggregator.

 Note that it may take up to 10 minutes to see traffic for a new user. This is the time needed for the application to create the finest sample of traffic since the sample lasts 5 minutes and two samples are needed to draw a line on the chart.